MILLER ENPAK A60
Check against the official notice below — it lists the full affected range.
Miller Electric is recalling certain EnPak A60 Diesel Engine-Driven All-In-One units (Models A60GB, A60GBH, and A60GBHW with specific stock numbers) manufactured between July 16, 2021, and February 16, 2022, with serial numbers between NB290697R and NC080172R. A bracket inside the unit may have been installed with inadequate clearance, which can allow the drive belt to damage the ground wire, battery cables, and fuel hoses. Additionally, insufficient clearance between the output inductor and frame can cause an electrical arc. These conditions create a fire hazard.
Dealers will inspect and replace the ground wire, battery cables, and fuel hoses as necessary, and will install a larger bracket and a new bracket between the output inductor and frame. All repairs will be performed free of charge. Owner letters were mailed May 27, 2022. Owners should contact Miller customer service at 1-920-735-4505 for information about obtaining the free repairs.
Written by software from the official notice below. Not reviewed by a lawyer.
A damaged power cable or diesel fuel hose can cause an electrical short-circuit or fuel leak. Output inductor contact with the frame can cause an electrical arc. Any of these scenarios can increase the risk of a fire.
Dealers will inspect and replace the ground wire, battery cables, and fuel hoses, as necessary, and install a larger bracket. A new bracket will also be installed between the output inductor and frame. Repairs will be performed free of charge. Vehicle upfitters were notified February 28, 2022. Owner letters were mailed May 27, 2022. Owners may contact Miller customer service at 1-920-735-4505.
Miller Electric MFG. CO. (Miller) is recalling certain EnPak A60 Diesel Engine-Driven All-In-One Air Compressor/Generator/Battery Charger/Crank Assist/Hydraulic Pump/Welder (Model A60GB - Stock Numbers 907813, 907813001, Model A60GBH - Stock Numbers 907814, 907814001 and Model A60GBHW - Stock Numbers 907815, 907815001). All units are within the following serial number range NB290697R NC080172R and were manufactured between July 16, 2021, and February 16, 2022. A bracket inside the EnPak All-In-One unit may have been installed with inadequate clearance, allowing the drive belt to contact other components, and potentially causing damage to the ground wire, battery cables, and fuel hoses. In addition, a lack of clearance between the output inductor and EnPak All-In-One frame may cause an electrical arc.
Republished from the official source above; details can change — the source record controls.