2007 HONDA FIT; 2008 HONDA FIT
Check against the official notice below — it lists the full affected range.
Honda is recalling certain 2007-2008 Fit vehicles because the plastic cover on the master power window switch may separate over time, allowing water to enter and damage the switch. If the switch becomes damaged from water intrusion, it can overheat and potentially cause smoke, melting, and fire.
Owners should contact Honda at 1-800-999-1009 (recall number JA6) to receive notification about having their vehicle inspected at a Honda dealer at no cost. Depending on inspection results, owners will either have a damaged switch replaced or will receive a second notification instructing them to return to the dealer for a replacement switch installation, both at no charge.
Written by software from the official notice below. Not reviewed by a lawyer.
An overheated switch can cause smoke, melting and fire.
Honda will notify owners in July 2013 and will instruct owners to take their vehicles to dealers to have a free inspection conducted. If the switch is damaged, it will be replaced free of charge. If the switch is not damaged, the owner will be instructed to await a second notification that will instruct them to return to the dealer to have a replacement switch installed free of charge. Honda anticipates it will have sufficient parts inventory to notify owners of vehicles with undamaged switches to return to dealers for replacement switches in Fall 2013. Renotification was sent out to owners on July 23, 2014. Owners may contact Honda at 1-800-999-1009. Honda's recall number is JA6.
Honda is re-recalling certain model year 2007-2008 Fit vehicles covered under previous recall 10V-033. The remedy applied in this earlier recall may have been insufficient. In the affected vehicles, over time, the plastic cover may separate from the master power window switch allowing water to enter the driver's window and reach the master power window switch. If the master power window switch is damaged as a result of the water intrusion, overheating and failure of the switch may result.
Republished from the official source above; details can change — the source record controls.