DeWALT® cordless kerosene forced-air heaters
Check against the official notice below — it lists the full affected range.
Enerco Group is recalling DeWALT cordless kerosene heaters because they can restart unexpectedly while in standby mode if the room temperature drops below the thermostat setting. This unexpected restart poses fire and carbon monoxide poisoning hazards. The recall affects model numbers DXH90CFAK (serial numbers 340902-20001001 through 340902-20004000) and DXH90CFAKM (serial numbers 340901-20001001 through 340901-20001500). The heaters have a black tank/base, yellow body, and gray combustion barrel with "DeWALT" and "90,000 BTU" printed in yellow on the combustion barrel. The model and serial numbers are located on the side panel opposite the controls.
According to the recall, consumers should immediately stop using the recalled heaters and contact Enerco for a free replacement corded heater.
Written by software from the official notice below. Not reviewed by a lawyer.
The heaters can re-start unexpectedly while in standby mode if the room temperature falls below the thermostat set point, posing fire and carbon monoxide poisoning hazards.
Consumers should immediately stop using the recalled heaters and contact Enerco for a free replacement corded heater.
This recall involves DeWALT cordless kerosene forced-air heaters model number DXH90CFAK with serial numbers 340902-20001001 through 340902-20004000 and model number DXH90CFAKM with serial numbers 340901-20001001 through 340901-20001500. The heaters have a black tank/base, a yellow body and a gray combustion barrel. "DeWALT" and "90,000 BTU" are printed in yellow on the combustion barrel. The model number and serial number are located on the side panel opposite the controls.
Official record: U.S. Consumer Product Safety Commission ↗
Republished from the official source above; details can change — the source record controls.