← Search recalls
NHTSARecalled 2013-08-27

Trans-Air Manufacturing Corp. — EQUIPMENT

Is my product affected?

TRANS/AIR COMPRESSOR MOUNT KIT

  • Brand TRANS/AIR

Check against the official notice below — it lists the full affected range.

What happened

Trans/Air Manufacturing is recalling Compressor Mount Kits with specific part numbers that were installed between June 1, 2010 and June 15, 2013 on Ford vehicles with 5.4 or 6.8 liter engines. The spring clamp on the heater hose at the front of the intake manifold may pinch the alternator harness between itself and the compressor mounting bracket, creating two potential hazards: the charging system could fail and cause the vehicle to stall while driving, and the pinched wires could short circuit and cause a fire.

Trans/Air will notify owners and dealers will repair the vehicles at no charge by inspecting them, correcting the clamp installation, and repairing the alternator harness as needed. The recall began in October 2013. Affected consumers should contact Trans/Air at 1-800-673-2446 and reference recall number 13-002.

Written by software from the official notice below. Not reviewed by a lawyer.

Hazard

The charging system may fail which could lead to the vehicle stalling while driving, increasing the risk of a crash. Additionally, the spring clamp could pierce both the positive and negative wires of the alternator harness creating a short circuit which could result in a fire.

What should I do?

Trans/Air will notify owners and dealers will inspect the vehicles, correct the clamp installation and repair the alternator harness, as needed, free of charge. The recall began during October 2013. Owners may contact Trans/Air at 1-800-673-2446. Trans/Air's recall number is 13-002.

Details from the source

Trans/Air Manufacturing (Trans/Air) is recalling certain Compressor Mount Kits with part numbers: 4012666-01, 4012666-02, 4012676-01 and 4012676-02; and installed between June 1, 2010 and June 15, 2013 onto Ford 5.4 or 6.8 Liter engines. Depending on the routing of the alternator harness, and the orientation of the heater hose spring clamp at the front of the intake manifold, the alternator harness may be pinched between the spring clamp and the compressor mounting bracket.

Source

Official record: NHTSA ↗

Republished from the official source above; details can change — the source record controls.

Related recalls

All NHTSA recalls

Hurt by this product? Start a free Case Check

ProductRisk is not a law firm and does not provide legal services or legal advice. ProductRisk is a free consumer product-safety information service operated by Plaintify, Inc., a technology company. If you ask to be connected with a law firm, any legal services are provided by that firm — not by ProductRisk or Plaintify.

Privacy · Plaintify