2010 NISSAN ARMADA
Check against the official notice below — it lists the full affected range.
Nissan is recalling certain 2010 Nissan Armada vehicles manufactured between June 7 and June 11, 2010. The second row center seat hinge assembly in these vehicles was manufactured out of specification, which may prevent the rear center seatback from fully locking in the upright position. In the event of a crash, this defect could cause the seat to not function properly and increase the risk of injury to an occupant.
To remedy this issue, dealers will inspect the second row center seat hinges and lock for proper function. If the seat does not lock as designed, Nissan will replace the second row center seat hinge assembly with a new one at no charge. Affected owners should contact Nissan at 1-800-647-7261 to schedule an inspection and repair.
Written by software from the official notice below. Not reviewed by a lawyer.
IN THE EVENT OF A CRASH, THE SECOND ROW CENTER SEAT MAY NOT FUNCTION PROPERLY INCREASING THE RISK OF INJURY TO THE SEAT OCCUPANT.
DEALERS WILL INSPECT THE SECOND ROW CENTER SEAT HINGES/LOCK FOR PROPER FUNCTION. IF THE SEAT DOES NOT LOCK AS DESIGNED, THE SECOND ROW CENTER SEAT HINGE ASSEMBLY WILL BE REPLACED WITH A NEW ONE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 30, 2010. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
NISSAN IS RECALLING CERTAIN MODEL YEAR 2010 NISSAN ARMADA VEHICLES MANUFACTURED FROM JUNE 7, 2010 THROUGH JUNE 11, 2010. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS." THE SECOND ROW CENTER SEAT HINGE ASSEMBLY WAS MANUFACTURED OUT OF SPECIFICATION. THIS MAY PREVENT THE REAR CENTER SEATBACK FROM FULLY LOCKING IN THE IN-USE (UPRIGHT) POSITION.
Republished from the official source above; details can change — the source record controls.