Sta-Rite System 2 and AquaTools Filters and Filter Systems
Check against the official notice below — it lists the full affected range.
Sta-Rite Industries is recalling certain System 2 pool filters sold under the Sta-Rite and AquaTools brand names because the Posi-Lok™ locking ring that holds the filter's upper tank to the lower tank can disengage, causing the top of the filter to blow off and potentially injure people nearby. The affected filters are cylindrical tanks measuring 27 inches high and 18 inches in diameter, with model numbers beginning with PLM, PLD, AT84100, AT84150, or AT82130, and with specific serial numbers beginning with 1A03, 1B03, 1C03, 1D03, 1EH03, 1F03, 1G03, 1H03, or 1J03 (where the 5th character does not matter). Filters with updated Posi-Lok™ locking rings that have the phrase "Lubricate Tank "O" Ring - see instructions" molded into them are not affected.
Consumers with an affected filter should not disturb it and should call Sta-Rite toll-free at (866) 681-9148 to confirm their filter's identity. Sta-Rite will send a free replacement locking ring with installation instructions and will reimburse $10 for each ring shipped back using a pre-paid box. For consumers uncomfortable installing the replacement themselves, Sta-Rite will arrange professional repair at no cost.
Written by software from the official notice below. Not reviewed by a lawyer.
The Posi-Lok™ locking ring, which secures the filter's upper tank shell to the lower tank shell (see diagram), can disengage from the lower tank shell, allowing the top shell of the filter to blow off, causing injury to nearby consumers.
Consumers should check the filter model plates to locate model numbers and serial numbers. Consumers should not disturb their filters and contact Sta-Rite toll-free at (866) 681-9148 to confirm the identity of their filter and receive a free replacement Posi-Lok™ locking ring and installation instructions. In addition, Sta-Rite will reimburse consumers $10 for each Posi-Lok™ locking ring that is shipped back to them and provide a pre-paid box for shipping. For consumers who are not comfortable with the replacement procedure, Sta-Rite will arrange to have the affected filters professionally repaired at no cost to the consumers.
These modular pool filters are designed for use with above ground pools and small in-ground pools. These filters are used to remove particles from the water. The System 2 product line is sold under the brand names "Sta-Rite" and "AquaTools," located on a decal on the upper tank shell. The cylindrical filter tank measures 27 inches high and 18 inches in diameter. Sta-Rite System 2 filter tanks were sold with model numbers beginning with PLM or PLD and AquaTools filter tanks were sold with model numbers beginning with AT84100, AT84150 or AT82130. Serial numbers are located on on the nameplate decal on the upper tank shell. Only filters with the following serial numbers are affected (the 5th character is irrelevant for the purposes of this recall): 1A03_ 1B03_ 1C03_ 1D03_ 1EH03_ 1F03_ 1G03_ 1H03_ 1J03_ If the Posi-Lok™ locking ring has the phrase "Lubricate Tank "O" Ring - see instructions" molded into it, the ring has been updated and no further action is necessary for that filter.
Official record: U.S. Consumer Product Safety Commission ↗
Republished from the official source above; details can change — the source record controls.