Invacare AVIVA Storm RX with LiNX Gyro Power Wheelchair (with LiNX Gyro Module Model Numbers DLX-GRY100-A and DLX-GRY101-A) Models: SRX-20R, SRX-20SP, SRX-20MP
Check against the official notice below — it lists the full affected range.
Invacare Corporation has recalled Invacare AVIVA Storm RX power wheelchairs equipped with LiNX Gyro modules (models DLX-GRY100-A and DLX-GRY101-A) running firmware version 6.1.2. The affected wheelchair models are SRX-20R, SRX-20SP, and SRX-20MP. The issue occurs because these wheelchairs can experience a more aggressive deceleration rate than the programmed rate when the system follows an incorrect deceleration profile, which poses a potential injury risk to users.
One unit in the United States has been affected by this recall, with worldwide distribution also reported in Canada, Australia, Thailand, and New Zealand. The source document does not specify a remedy for affected consumers.
Written by software from the official notice below. Not reviewed by a lawyer.
Power Wheelchairs with a LiNX Gyro component running firmware version 6.1.2 can experience a more aggressive deceleration rate than the programmed rate due to the system following the incorrect deceleration profile, resulting in potential injury
Reason for recall: Power Wheelchairs with a LiNX Gyro component running firmware version 6.1.2 can experience a more aggressive deceleration rate than the programmed rate due to the system following the incorrect deceleration profile, resulting in potential injury Distribution: Worldwide distribution - US Nationwide and the countries of Canada, Australia, Thailand, New Zealand. Quantity: 1 unit US Lot/code info: LiNX Gyro firmware version 6.1.2 UDI-DI Numbers: SRX-20MP 00841447114581 SRX-20R 00841447114604 SRX-20SP 00841447114598
Official record: FDA (Device enforcement) ↗
Republished from the official source above; details can change — the source record controls.