Check against the official notice below — it lists the full affected range.
Singer Company and Ranco Electric are recalling certain Sears Craftsman scroller saws that were repaired with a specific replacement circuit board between October 1980 and June 1984. The recalled models are the Commercial Auto Scroller Saw (Model No. 315.26750) and the Multi-Speed Scroller Saw (Model No. 315.26710). These saws pose an electrical shock hazard due to the defective circuit board. Approximately 1,600 saws are affected by this recall, and no accidents or injuries have been reported.
According to the recall notice, consumers who own these models should immediately stop using them and return the saws to the Customer Service Counter at their nearest Sears store. The replacement circuit boards will be installed at no charge. Consumers needing more information can call toll-free at 800-845-4781 or 800-922-7780 in South Carolina.
Written by software from the official notice below. Not reviewed by a lawyer.
Electrocution/Electric Shock
Scroller Saws Recalled by Singer NEWS from CPSC U.S. Consumer Product Safety Commission Office of Information and Public Affairs Washington, DC 20207 FOR IMMEDIATE RELEASE January 18, 1985 Release # 85-004 Recall Of Scroller Saws With Replacement Circuit Boards (Washington, D.C.) -- The Singer Company, Stamford, Connecticut and Ranco Electric, Irving, Texas, in cooperation with the U.S. Consumer Product Safety Commission, today announced the recall of any Sears Craftsman Commercial Auto Scroller Saws, Model No. 315.26750 and Craftsman Multi-Speed Scroller Saws, Model No. 315.26710 which have previously been repaired with this replacement circuit board. Saws which have been repaired with this replacement circuit board could pose an electrical shock hazard. Only saws of these two model numbers repaired since October, 1980 through June, 1984, are subject to recall. The model number for the saws may be found on the saw motor plate. These saws were sold through Sears stores and catalogs between 1968 and 1972 for an estimated $60.00 each. However, the only saws affected are approximately 1,600 which were repaired with the Ranco circuit board between October, 1980 and June, 1984. There have been no reports of accidents or injuries associated with the use of the saws repaired with the replacement circuit boards. Consumers should immediately stop using these saws and return them to the Customer Service Counter of their nearest Sears store. The circuit boards will be replaced at no charge. Anyone wishing additional information may call toll-free 800-845-4781 (or 800-922-7780 in South Carolina).
Official record: U.S. Consumer Product Safety Commission ↗
Republished from the official source above; details can change — the source record controls.